We are receiving a number of questions regarding access to hitch pins, and fitment of bike rack locks on the 2015 Subaru WRX EcoHitch.  Due to the hidden design of EcoHitch behind the rear bumper, people have expressed concern there may not be adequate space around the hitch receiver to easily install and remove these accessories.  There are two options during installation of the EcoHitch that provide simple solutions to these concerns.  They are detailed below:

OPTION 1(Recommended)
Due to the tight tolerance of the body of the vehicle in relation to the bumper cover it may be required to trim the portion shown in the image below, to allow for easy removal of the knockout panel as well as the ability to easily insert a hitch pin or bike rack lock into the hitch.
Carefully trim the highlighted section shown below.


Option 1 After Trim



As you can see in the photo above, trimming of the plastic panel is located on the bottom of the vehicle and is not visible from the back of the car.  
If Option #1 is not desired, remove the two lower clips shown by the arrows in the image below each time and gently pull the bumper back toward you to insert your hitch pin and lock. After you have your hitch pin lock inserted, you need to replace the clips on the bumper and use the hitch as desired.  We recommend Option #1 as it will provide quicker access to the hitch receiver and prevent wear and tear on components of the car. 


We hope these pictures and installation notes help clarify how EcoHitch for the 2015 Subaru WRX is able to easily accommodate all your favorite hitch accessories.  If you have questions or comments regarding this portion of the installation or any other, please don’t hesitate to contact us directly here or 877-373-9195. 
Get Out and Go Subie at Torklift Central