For owners who already run a SuperTruss and need a different length after a camper, trailer, or truck change.

Before you replace your SuperTruss with a different length, measure your loaded camper overhang again, confirm your SuperHitch model, check the clearance your trailer needs, and look up the rating for the new length and configuration on the current chart. A new length is a new setup. It can change your trailer and tongue weight ratings, the wiring pigtail you need, and whether weight distribution is required, so do not assume your old numbers carry over.

This guide is for current owners. If you are buying a SuperTruss for the first time, start with our SuperTruss extension buying guide instead.

Why Your Current Length May No Longer Work

A SuperTruss that was right for your last setup can be wrong for the next one. The most common reasons owners change length:

  • A new camper with more or less rear overhang than the old one.
  • Rear additions on the camper, such as steps or storage, that now stick out farther than the camper bumper.
  • A different trailer whose coupler area, tongue jack, propane tanks, or battery box needs more room to pivot.
  • A different truck or bed length that moves the receiver relative to the camper.
  • An extension that is longer than you need, where a shorter length could give your setup more rating headroom.

Longer is not automatically better. More reach adds leverage, and leverage affects ratings. The right length is the one your measurements call for.

Confirm the SuperHitch You Already Have

SuperTruss is a dual extension that works exclusively with Torklift's SuperHitch series. It is not designed for ordinary factory receivers. If your truck uses a Ford factory 3-inch receiver, Torklift's Cannon extension is the product built for that, and it is a different system from SuperTruss.

Find your SuperHitch model and part number on the hitch or in your order records before you shop. The rating you can use depends on the whole system: your truck's ratings, your SuperHitch, the SuperTruss length, the configuration, your ball mount, and your trailer. The lowest-rated component in that chain always controls.

What to Measure With the Camper Loaded

Measure with the camper on the truck, loaded the way you travel, and the truck parked on level ground. The truck sits lower with the camper on and rises when the camper comes off, so unloaded measurements will not match how the setup actually rides.

  • Camper overhang: measure from the face of the truck's rear bumper to the outside edge of the camper's bumper.
  • Rearmost protrusion: if steps, storage, or other additions extend past the camper bumper, measure to the rearmost point that a trailer could contact.
  • Current reference: note your current SuperTruss length and where your trailer coupler sits relative to the camper today. If the old setup was tight or had extra room, that tells you which direction to go.
  • Trailer swing clearance: check the tongue jack, propane tanks, battery boxes, and anything else at the front of the trailer. The trailer must be able to pivot in turns without contacting the camper.
  • Coupler height: compare your loaded hitch height to the trailer coupler height so you know what ball mount drop or rise you will need.

How a Different Length Changes Your Ratings

SuperTruss ratings vary by length and configuration, and Torklift publishes them on a rating chart for that reason. Configuration matters as much as length. Torklift's published figures for the 48-inch extension illustrate it: 12,000 pounds pull and 1,200 pounds tongue weight when used with a weight distribution system, but 6,000 pounds pull and 600 pounds tongue weight without one.

Your new length will have its own figures. Look them up for the exact length and configuration you plan to run before you order, and compare them to your loaded trailer weight and measured tongue weight. No hitch or extension increases your truck's factory towing capacity, payload, or GCWR.

Wiring, Weight Distribution, and Accessories

Wiring

Changing length can change the wiring you need. Torklift offers length-specific 7-pin pigtails for SuperTruss, including three-way harnesses for 21 to 28 inch, 32 to 36 inch, and 42 to 48 inch extensions, two-way options, and a 120-inch universal harness. A pigtail sized for your old extension may not reach, or may leave excess cable, on the new one.

Weight distribution

If the rating you need for the new length depends on weight distribution, confirm your system is compatible with the SuperTruss setup and plan to set it up again for the new geometry.

Safety chains and accessories

SuperTruss uses Torklift's lateral-support safety chain system. If you run a SuperTruss accessory such as the SkidWheel or the ExtendedPower Kit, confirm it works with the new length before ordering.

Available SuperTruss Lengths

SuperTruss comes in eight lengths from 21 to 60 inches. Ratings for each length and configuration are on the current SuperTruss rating chart.

Extension lengthPart number
21 inchesE1521
24 inchesE1524
28 inchesE1528
32 inchesE1532
36 inchesE1536
42 inchesE1542
48 inchesE1548
60 inchesE1560

Replacement Measurement Worksheet

Fill this in before you contact us. With these answers, our product specialists can review your new length and rating in one conversation.

ItemYour measurement or answer
Truck year, make, model, and bed length
SuperHitch model and part number
Current SuperTruss length
Camper make, model, and length (note if changed)
Loaded overhang: truck bumper face to outside edge of camper bumper
Rearmost camper protrusion, if beyond the bumper
Trailer type and loaded weight
Measured trailer tongue weight
Trailer front-end items that need swing clearance
Loaded hitch height vs. trailer coupler height
Weight distribution system used (model)
Current wiring pigtail
SuperTruss accessories in use
Target SuperTruss length
Rating for target length and configuration (from chart)

Compare SuperTruss Lengths or Send Us Your Measurements

When your setup changes, the extension should change with it. Review the available lengths in our extended towing systems category, check the rating chart for your target length and configuration, and confirm your wiring. For a full system rebuild, our guide to building a complete SuperHitch and SuperTruss order covers the hitch, extension, wiring, and weight distribution together.

Important: SuperHitch and SuperTruss do not increase your truck's factory towing capacity, payload, GVWR, GAWR, or GCWR. Ratings vary by extension length and configuration. Always stay within the limits of the lowest-rated component, including the truck, hitch, extension, ball mount, safety chains, and trailer.

Key Takeaways

  • A new SuperTruss length is a new setup with its own ratings, wiring needs, and weight distribution requirements.
  • Measure loaded overhang from the face of the truck's rear bumper to the outside edge of the camper bumper, plus anything that protrudes farther.
  • Configuration matters as much as length: Torklift's published 48-inch ratings are cut in half without weight distribution.
  • SuperTruss works only with SuperHitch series hitches; Ford factory 3-inch receivers use the separate Cannon extension.

Frequently Asked Questions

Can I keep my SuperHitch and just change the SuperTruss length?

Usually, as long as your hitch is part of the SuperHitch series. Confirm the rating for the new length and configuration on the current chart before ordering.

Will a longer SuperTruss lower my ratings?

Ratings vary by length and configuration. Look up the exact figures for the length you plan to use rather than assuming your old ratings carry over.

Should I measure with the camper on or off?

On. Measure with the camper loaded and the truck on level ground, because the truck sits lower with the camper on.

Will I need different wiring?

Possibly. Torklift offers length-specific pigtails, so a harness sized for your old extension may not suit the new one.

Can I use SuperTruss with my factory receiver?

No. SuperTruss works exclusively with the SuperHitch series. Ford trucks with a factory 3-inch receiver use the Cannon extension.

What if my measurement falls between two lengths?

Choose the length that clears your measured overhang and trailer swing needs, then confirm its rating on the chart. If you are unsure, send us your worksheet before ordering.

Changing length? Compare SuperTruss options in our extended towing systems category, or call a Torklift Central product specialist at 253-854-1832 with your completed worksheet.